Redsail Cutting Plotter Manuel d'utilisateur

1202009-05-19Blades 45 degrees package of 1 or 5 bladesBlades 60 degrees package of 1 or 5 bladesCutter strip Model 360C (12”)Cutter strip Model 450C

If you use a serial cable between cutter and computer, use the Com port available, normally is Com1 or Com2. (9 Pin Male on your computer)After Com po

2If you use vinyl roll, please before to cut unwind in advance the quantity of material necessary for the cutting.Place the pinch rolls about 1 inch i

CONTENTS(1) Cutting plotter models(2) Vinyl alignment(3) Contents(4) Notice when using your cutting plotter(5) Cutting plotter packaged accessories(6)

Notice(1) Sign Max cutting plotter’s power supply is 90V-230V, when your power supply does not fit the requirement, please add the right power cable.

Vinyl Cutter User Manual V5.0When you open the box, check the contents with the check list inside, make sure that nothing is missing, every box must c

Vinyl Cutter User Manual V5.0Main parts descriptionsFront side / Left and Right sides1) Protection cover2) Carriage3) Roller4) LCD display5) Keypad pa

How to install machine(1) Place the machine:Place the plotter in a clean room.Place the machine on a horizontal table, adjust plotter four foots, to k

Second method: USB connectionA) Install the WinPCSIGN softwareB) Install the RocKey2 key on a free USB port.C) Use the USB cable supplied with your cu

129Vinyl Cutter User Manual V5.08Run the WinPCSIGN software and from the Settings menu, click on Plotter Codes Then from the setup plotter window cli