Redsail Cutting Plotter Manuel d'utilisateur télécharger pdf (Page 9)

Vinyl Cutter User Manual V5.0

Run the WinPCSIGN software and from the Settings menu, click on Plotter Codes

Then from the setup plotter

window click on Add/Remove.

Locate your plotter model, select

it and click on the arrow

to place

the plotter in the visualization

windows to the right. Finally click

OK and Accept/Save

Your Cutter

Locate your plotter model, select it and click on the arrow

to place the plotter in the visualization windows to the

right. Finally click OK and Accept/Save

WinPCSIGN Cutter configuration

Vinyl Cutter User Manual V5.0

Draw a square or a rectangle on the working page.

Click on the Cutting icon, this will open the Cutting Control Panel

Press the Start button.

To test the equipment:

Draw rectangle near left hand bottom corner this represent the origin point (0,0)

Origin Point (0,0)

Your cutter

Cond1

Cond2

24,000

Origin Point (0,0)

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Redsail Cutting Plotter Manuel d'utilisateur Page 9