How to install machine
(1) Place the machine:
Place the plotter in a clean room.
Place the machine on a horizontal table, adjust plotter four foots, to keep
plotter very horizontally. Make enough space not only to the front of plotter
but also to the back of plotter.
No vibration when plotter is running. Don't touch the plotter with magnet.
We suggest you connect the machine's metals shell with the ground using a
metal wire, to avoid static electricity.
(2) First power on, examining plotter:
Set the power cable to machine power port, connect the power cable to
AC110V power. Turn the power ON, the green LED on the cutter keyboard
will light when power is on. Later, the carriage must move to right side itself,
and return a little. This is the initialization of cutting plotter. The message of
speed and pressure will be showed on the LCD monitor.
Followed are the machine parameters:
Speed: 600mm/s
Pressure: 150 grams
(3) Connect to computer:
RS232 cable
There are two ways to link a cutter to a computer:
First method: Serial connection ( )
A) Install the WinPCSIGN software
B) Install the RocKey2 key on a free USB port.
C) Use the serial cable supplied with your cutter, connect one end to the computer
serial port and the other end to the cutter serial port.
Power ON the cutter.
Run the WinPCSIGN software, from the setting menu, plotter codes configure the
WinPCSIGN software :
- Your cutter model normally SM cutter or RedSail cutter
- Select Com1 if free or select Com2 port
- Click the Accept/Save button.
Vinyl Cutter User Manual V5.0
7
14
Reset the plotter:
When the cutter works badly or if you wish to stop quickly the cutter, press
only once the “Reset” key. All data in the cutter memory will be erased and the
carriage will return to the right side near the cutter wall.
1) Press the button “ON Line” to see
the button light .
2) You can send data to the cutter
3) You can change speed using
4) You can change pressure
1) Press the button “ON Line to see
the button light .
2) You can press continuously DOWN
or UP arrow to move vinyl in or out the
cutter.
3) You can press continuously LEFT
or RIGHT arrow to move the carriage
head anywhere.
4) If you press the “OK” button you
define a new origin where the head is
placed.
Summary of the operation in “ON Line” mode
green
Summary of the operation in “OFF Line” mode
red
Vinyl Cutter User Manual V5.0
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels